CASO DESIGN Barista Flavour Mode D'emploi page 35

15 Operation and Handing
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages.
15.1 Before first use
Clean the the device as shown in chapter cleaning.
► When using for the first time little smell occurs. This is harmless and disappears after a
while.
15.2 Assembling
Assemble bean container with the holder as follows:
Place bean container on the holder so that the safety
pin (A) at bean container will snap into the intake (B) at
housing.
Then turn bean container clockwise (Fig 1)
The device is equipped with microswitch so that it must
be assembled correctly before operation or the device
will not work.
When disassemble press the release button for bean
container and turn the bean container anti-clockwise so that you
can remove the bean container.
15.3 Operation
1. Place the coffee grinder on a flat surface.
2. Pour appropriate amount of coffee beans into the bean container.
► Do not fill more than 300 g of beans in the bean container.
► If run the device without coffee beans it will stop working after 5 minutes.
► Operate the device continuously not longer as 5 minutes.
► The device must cool down 30 minutes if it is operated for 5 minutes continuously.
3. Close the lid of the bean container.
4. Hold the container for the ground coffee (with the lid) unter the seal at coffee ground
outlet and gently push the container on the holder.
5. Ensure that the opening of the container flushes with the outlet for ground coffee.
6. Turn the knob for coarseness on desired coarseness (1 = fine, 15 = coarse).
Please note
Please note
Please note
35