Car-O-Liner CMI 300 PULSE Guide De L'utilisateur page 15

Special functions
Software / Licenses
I
Torch setup
I
Error handling
CMI Pulse has a sophisticated built-in self-protection system. The machine automatically stops the gas supply, interrupts the welding
current and stops the wire feeding in case of an error.
Selected errors:
Gas control error (IGC)
A gas control error can be due to too low or too high gas flow.
Check that the pressure of the gas flow is higher than 2 bar and lower than 6 bar, corresponding to 5 l/min and 27 l/min.
Correct the gas error by adjusting the manual gas flow to 27 l/min. Reset the the gas error by briefly pressing the
Error log
I
All manuals and user guides at all-guides.com
II
II
II
15
III
III
III
Error log
All errors are saved in the
machine error log in the
menu Service. The error
log can be distributed, by
inserting an SD-card and
pressing the following
key:
The error log is now
saved at the SD-card.
Reset the error log by
pressing the trash bin
key.
P
-key.