Storing Frozen Food; Freezing Fresh Food; How To Use The Accessories - Beko NDU 9900 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GB

Storing frozen food

Your freezer is suitable for the long-term
storage of commercially frozen foods and also
can be used to freeze and store fresh food.
If there is a power failure, do not open the
door. Frozen food should not be affected if
the failure lasts for less than 15 hrs. If the
failure is longer, then the food should be
checked and either eaten immediately or
cooked and then
re-frozen

Freezing fresh food

Please observe the following instructions to
obtain the best results.
Do not freeze too large a quantity at any one
time. The quality of the food is best preserved
when it is frozen right through to the core as
quickly as possible.
Do not exceed the freezing capacity of your
appliance in 24 h.
Placing warm food into the freezer
compartment causes the refrigeration machine
to operate continously until the food is frozen
solid. This can temporarily lead to excessive
cooling of the refrigeration compartment.
When freezing fresh food, keep the thermostat
knob at medium position. Small quantities of
food up to 1/2 kg. (1 lb) can be frozen without
adjusting the temperature control knob.
Take special care not to mix already frozen
food and fresh food.
Instructions for use

How to use the accessories

Zero temperature compartment
(Fig. 5)
This compartment has been designed to store
frozen food which would be thawed slowly
(meat, fish, chicken...etc.) as required or food
wouldn't be frozen and after a short time would
be consumed in a better and healthier
condition. Don't put dairy products or similar
foods won't be frozen as required into this
compartment which is the coldest place of the
refrigerating compartment.
Crisper separators (Fig. 6)
These colourful separators in the crispers have
been designed to keep your vegetables and
fruit fresh and protect them against smashing.
By moving the separator forward, you can
keep them in the created room at the back of
it. As it is not required in use, the separator
can be pushed back and locked.
Ice – matic (Fig. 7/8)
Ice – matic water is fed from the ice – matic
water transfer box. After removing the ice -
matic water transfer box, it should be filled
with water. Waiting for two minutes, put it on
its place. The water reservoirs of the ice –
matic will be filled automatically. Your ice will
be ready in about two hours. You needn't take
the ice-matic out in order to get ice; just turn
it 90 to the right., and the ice will drop into the
ice-bowl below. Then take out the ice-bowl to
serve the ice. If you wish, you can leave the
ice in the bowl for a while.
Attention! After filling and putting on its place,
the ice-matic water transfer box should be
pushed until hearing the "click" voice. If there
exists some ice in the box you should wait it
to melt. When the elastic part, which is attached
to the front of the ice-matic water transfer box,
is removed it should be reattached so that
the water transfer hole should be placed to
the bottom. It should be carefully controlled
that this elastic part attached well.
5

Publicité

Table des Matières
loading

Table des Matières