INVERTO.TV Scena 5 m IDL 5650S Notice D'utilisation page 14

Note: The receiver is able to switch on some TV sets that use the "Slow Blanking" signal on the SCART
connector. If "Last Mode" is selected, the receiver and TV will power-up at the same time.
Auto Upgrades
By choosing "Notify", you will see a symbol in the upper part of the OSD when a new update is available.
By choosing "Auto" your receiver will be automatically updated while in stand by.
Function for "Option" key
This option allows to assign a user-defined functionality to the «Option» key.
Function for "Connect" Key
This option allows to assign a user-defined functionality to the «Connect» key.
Energy saving
When this option is activated, the receiver will enter a deep sleep energy saving mode when entering standby
mode as long as there are no scheduled recording events programmed on the Personal Planner.
anTenna SeTTIngS
To set up the receiver for the type of antenna connected,
follow the instructions below.
Signal strength and signal quality bars
In two level bar meters, on the right side of the screen, the
user can see the strength and quality of the signal coming
from the antenna dish to the tuners. These two meters can
be used while doing a fine-tuning of the antenna position.
The antenna has to be adjusted to have maximum possible
signal strength and signal quality.
LNB Type
Select Universal for most standard LNBs, or Unicable if you
have a Unicable LNB.
Motor System
If a motorized dish is connected to the digital receiver, use
this option to set the system used for sending commands to the motor.
Motorized dish
If you select one of the options for motorized dish and press the "Yellow" function key, a new menu bar will be
open. Here, you are able to adjust and set the position of this satellite. The two level bar meters can be used
during adjustment. Use the color keys on the remote control, as shown at the bottom of the screen, to move the
dish and set the limits.
The "Yellow" "Recalculate" key is used to recalculate all satellite positions, if the base position of the dish has
been moved. if you move the dish, simply enter the menu, adjust the position for only one satellite and press the
"Yellow" function key. The receiver will recalculate all positions accordingly.
Satellite
Use this option to select the satellite for which you would like to set the position.
Reference transponder
This option allows you to set which transponder is used as the reference.
Move the dish
Use this option to set the dish movement speed to "Fine" or "Coarse."
Limits
Use this option to turn on or disable the set limits.
Insert or delete a satellite from the list
You can add satellites to the list and set their individual settings and position, if using a motorized dish. Use the
color keys on the remote control, as shown at the bottom of the screen, to delete, insert, or set the motorized
position of each satellite.
LOF Low and High Band
The LOF (Local Oscillator Frequency) of the LNB is usually printed on the LNB itself or in its documentation. You
can set the High and Low LOF frequencies to match the LNB here.
9