Beamz ILLUSION 2 Manuel D'instructions page 5

DISPLAY
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)
into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
MENU FUNCTION SETTING
1）DMX address setting
1. Press <MENU> to enter EDIT interface.
2. Press <UP/DOWN> to choose, then press <ENTER> to enter (DMX address).
3. Press <Up/Down> to choose address 001~XXX.
4. Press <ENTER> to confirm, or press "MENU" to exit.
2）Channel mode Setting
1. Press <MENU> to enter EDIT interface.
2. Press <UP/DOWN> to choose, then press ENTER to enter (Channel mode).
Press UP/DOWN to choose each channel "12CH" or "23CH".
3.
4. Press ENTER to confirm, or press "MENU" to exit.
3) Scene Setting
1. Press <MENU> to enter EDIT interface
2. Press< UP/DOWN> to choose, then press ENTER to enter (Scene Choose)
Press< UP/DOWN> to choose light's three shows:Sh1,Sh2,Sh3 (can choose any show mode which is activated by
3.
sound).
4. Press <Enter> to confirm, or press "MENU" to exit.
4）Master-slave setting
1. Press <MENU> to enter EDIT interface.
2. Press <UP/DOWN> to choose, then press ENTER to enter (Master Mode).
3. Press <UP/DOWN> to choose Mast/SL1.
4. Press <Enter> to confirm, or press "MENU" to exit.
5）DMX Lost Setting
1. Press< MENU> to enter EDIT interface.
2. Press <UP/DOWN >to choose, then press ENTER to enter (Lost DMX mode).
press< UP/DOWN> can choose light's 4 scenes: hold, sound, auto and black
3.
(can choose any scene mode to operate).
4. Press <Enter> to confirm, or press "MENU" to exit.
The control board offer several features: you can simple set the starting address,
run the pre-programmed program or make a reset. The main menu is accessed
by pressing the Mode-button, browse through the submenu by pressing Up or
Down.
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing Up or Down. Confirm every selection
by pressing the Enter-button.
You can leave every mode by pressing the Mode-button. The functions provided
are described later in this manual.
5