Installation - Indesit PIM 631 AS Mode D'emploi

Installation

! Before operating your new appliance please read this
instruction booklet carefully. It contains important information
for safe use, installation and care of the appliance.
! Please keep these operating instructions for future reference.
Pass them on to possible new owners of the appliance.
Positioning
! Keep packaging material out of the reach of children. It can
become a choking or suffocation hazard (see Precautions
and tips).
!
according to the instructions provided. Incorrect installation
may cause harm to people and animals or may damage
property.
! This unit may be installed and used only in permanently
ventilated rooms in accordance with British Standard
be observed:
that expels any combustion fumes. This may consist of
a hood or an electric fan that automatically starts each
time the appliance is switched on.
In a chimney stack or branched flue.
(exclusively for cooking appliances)
must not be less than 2 m
The air circulation system may
take air directly from the outside
by means of a pipe with an inner
cross section of at least 100 cm
the opening must not be vulnerable
A
to any type of blockages.
Examples of
ventilation holes
for comburant air.
The system can also provide the air
Adjacent Room to be
Room Vented
needed for combustion indirectly,
air circulation tubes as described
above. However, these rooms must
not be communal rooms, bedrooms
Enlarging the ventilation slot
between window and floor.
hazard.
Directly to
the Outside
3
than air. Therefore, rooms containing LPG cylinders must
the event of a leak. As a result LPG cylinders, whether
partially or completely full, must not be installed or stored
in rooms or storage areas that are below ground level
(cellars, etc.). It is advisable to keep only the cylinder
being used in the room, positioned so that it is not subject
stoves, etc. ) which could raise the temperature of the
cylinder above 50°C.
Fitting the appliance
The following precautions must be taken when installing
the hob:
the top of the hob must be at least 600 mm from the edge
of the hob.
installation instruction manuals and at a minimum
600mm min.
Fastening hooks are provided, allowing you to fasten
the hob to tops that are between 20 and 40 mm thick.
To ensure the hob is securely fastened to the top, we
recommend you use all the hooks provided.
2
Hook fastening diagram
Hooking position
for top H=20mm
If the hob is installed beneath a wall
cabinet, the latter must be situated
at a minimum of 700 mm above
the hob.
555 mm
Hooking position
for top H=30mm
GB
23