EARTHING AND SHORT-CIRCUIT EQUIPMENT
LOW VOLTAGE ELECTRIC PANELS
COMPOSITION
4 MPUBTH aluminium alloy clamps with screw tighten.
1 insulated grip with polivalent head.
3 copper cables with PVC insulation of 35 mm² section and 0,6 m long.
1 copper cable with PVC insulation of 25 mm² section and 2 m long.
1 TT-38A milling earthing lathe.
1 plastic case to store and transport the equipment.
Composition according to customer specification.
CHARACTERISTICS
Short-circuit current "Icc": See table.
Temperature range: -25°C a 55°C.
INSTRUCTIONS FOR USE
1. Place the earthing screw and tighten it firmly to prevent it coming loose from its anchor point accidentally.
2. Place the first clamp in the grip and fix it to the first conductor, tightening it firmly to prevent it coming loose
accidentally.
3. Proceed with the other three clamps in the same way as the first, always ensuring proper tightening onto the
conductor.
4. To uninstall the equipment, proceed in the reverse order.
MAINTENANCE
Before and after using the earthing and short-circuit equipment, clean and check all the parts if any defect is
detected, it must not be used and it must be rejected.
To replace or repair any piece of the equipment, please contact SOFAMEL, S.L.