Publicité
Applications
The Peavey TriFlex
II System has a variety of applications such as DJ, sound reinforcement, public address, or
™
karaoke. It can even be used as a pair of powered monitors by turning the Subwoofer level all the way down.
A typical signal source for the line-level inputs of the Peavey TriFlex II would be a sound reinforcement mixing
console (mixer) or the output from a CD player, MP3 player or tape deck.
REAR PANEL BOTTOM
2
3
1
FUSE (1)
The unit is AC power line fuse protected from overloads and fault conditions with a slow-blow 4.0 Amp 250V
fuse. This fuse is located within the cap of the fuse enclosure just to the left of the ON-OFF switch. If the
fuse fails, THE FUSE MUST BE REPLACED WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO
THE EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY The fuse in the TriFlex II can be replaced with a
time-delay type 5 x 20 mm size, 4 amp 250V rated fuse, which conforms to the international fuse classification
"T4AL". In the USA, types GDC, GMC, 215, 218, and 477 cartridge-style 5 x 20 mm size fuses with a 4 amp 250V
rating can be used. If the unit continues to blow replacement fuses, do not keep replacing them, it should be
taken to a qualified service center for repair.
IEC POWER CORD CONNECTION (2)
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit. It is very important that
you ensure the TriFlex II has the proper AC line voltage supplied. You can find the proper voltage for your TriFlex
II printed next to the IEC line (power) cord on the rear panel of the unit.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment. Never
break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a
ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To
prevent the risk of shock or fire hazard, always be sure that the mixer and all other associated equipment are
properly grounded.
ON-OFF SWITCH (3)
This rocker switch supplies AC power to the TriFlex II when switched to the ON position. The ON position is with
the right side of the switch pushed "in" or nearly flush with the rear panel.
16
Publicité
