Black & Decker BXJB1200E Mode D'emploi page 5

♦ Put the ingredients, after having first chopped them into
small piece, into the jar with liquid (do not exceed the
maximum marker).
♦ Put the lid on the jar by turning clockwise; make sure it is
properly fixed in place.
♦ Put the measuring cup in the lid.
♦ Connect the appliance to the mains.
♦ Turn the appliance on, by using the selection knob.
♦ Select the desired speed.
♦ If you wish to add more ingredients pull out the meas-
uring cup.
♦ Add the ingredients and replace the measuring cup.
♦ To stop the appliance set the speed back to "0".
♦ To avoid a fierce start up of the appliance, it is advisable
to start off from the lowest speed position and, once the
appliance has been switched on, progressively increase
the speed to the desired position.
Electronic speed control:
♦ The speed of the appliance can be regulated by using
the speed regulator control (G). This function is very
useful, as it makes it possible to adapt the speed of the
appliance to the type of work that needs to be done.
"Pulse" Function
♦ The appliance works in highest speed to achieve optimal
performance.
♦ Press this button to operate and release the button when
you wish to stop operating.
♦ We recommend working by pressing the button in cycles
of 3 seconds and repeating the operation until you obtain
the desired result.
"Ice crush" Function
♦ This function gives optimal result for ice-crushing, up to
desired snowy level.
♦ To stop the function, press the button again.
"Smoothie" Function
♦ This function gives optimal result for smoothies to
achieve desired texture.
♦ To stop the function, press the button again.
Once you have finished using the appli-
ance:
♦ Stop the appliance, selecting position 0 on the selector
control.
♦ Unplug the appliance from the mains.
(Original instructions)
♦ Turn the jar anticlockwise and remove it from the motor
body.
♦ Clean the appliance.
Safety thermal protector:
♦ The appliance has a safety device, which protects the
appliance from overheating.
♦ If the appliance turns itself off and does not switch itself
on again, disconnect it from the mains supply, and wait
for approximately 15 minutes before reconnecting. If the
machine does not start again seek authorised technical
assistance.
CLEANING
♦ Disconnect the appliance from the mains and allow it to
cool before undertaking any cleaning task.
♦ Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry.
♦ Do not use solvents, or products with an acid or base pH
such as bleach, or abrasive products, for cleaning the
appliance.
♦ Do not let water or any other liquid get into the air vents
to avoid damage to the inner parts of the appliance.
♦ Never submerge the appliance in water or any other
liquid or place it under running water.
♦ During the cleaning process, take special care with the
blades, as they are very sharp.
♦ It is advisable to clean the appliance regularly and
remove any food remains.
♦ The following pieces may be washed in a dishwasher
(using a soft cleaning program):
Jug (without its blades)
Lid
Measuring cup
♦ Then dry all parts before its assembly and storage.
Self-cleaning function:
♦ Put water and a small amount of washing up liquid in
the jar.
♦ Select the function "turbo".
Removable Blades for Effective Cleaning
(Jar Blender Only)
♦ Loosen the blade fixing ring by turning it in counter clock-
wise direction. (Fig.2).
♦ Remove the blade fixing ring, blade set, sealing ring and
clean them.
ENGLISH
5