Publicité
Les langues disponibles
Les langues disponibles
8155525
OPERATION
NOTE: Although the charger is overload, short circuit and polarity reversal protected; the following
basic battery charger procedures should still be followed.
1.
Turn the current switch on the charger to the desired charge rate for the battery
being charged.
2.
Clamp the red clip of the charger to the positive (+) polarity post of the battery, and the black
clip to the negative (-) polarity post, and confirm that the connection is correct.
3.
Connect the battery charger to the power supply.
4.
Check the charger indicator light to ensure the correct connections. The charger will not start
unless it is hooked up correctly.
NOTE: The charger is designer to charge 12 volt batteries only. It will not function as a source of
12 volt power. It will not produce a spark if the positive (+) and negative (-) clamps are touched
together nor will it give a reading if it is hooked to a multi-tester or volt meter. The charger will
not operate unless the initial battery voltage is above 7 volts. This is normal. The built in safety
features of short circuit and polarity reversal protection will not allow the charger to start unless it
is correctly connected to a 12 volt battery.
TROUBLE SHOOTING
Problem(s)
No charging current.
Battery will not charge /
insufficient charger output.
Loud noise coming from
the charger.
Visit www.princessauto.com for more information
10/2A Battery Charger
Possible Cause(s)
Bad contact to the wall outlet
Initial battery voltage is
too low.
Minimum voltage required
before the charger will start
is approximately 7 volts.
The positive (+) and negative
(-) polarity terminals of the
battery are oxidized or dirty.
The battery has
been damaged.
The battery is too old.
The battery is fully charged.
Improper placement.
Damaged charger.
Solution(s)
Repair or change the wall outlet.
Change the battery.
Change the battery.
Clean the terminals.
Repair or change the battery.
Change the battery.
The battery does not need charging.
Change the position for
proper placement.
Discontinue use. Replace the charger.
V 3.03
5
Publicité
