Conceptronic CBTHS2 Guide De Démarrage Rapide page 11

ENGLISH
A: Getting Started
Charging battery
The Conceptronic Earbridge comes with an embedded rechargeable battery. For first time
use, it takes about 4 hours to fully charge the battery. Afterward, it takes about 2 hours to fully
charge. With battery fully charged, the talk time is about 3 to 4.5 hours, and the stand-by time
will be about 100 hours.
1. Connect Travel Charger with AC power; the green indicator of charger will light up.
2. Connect the Charger, Connector and Headset as picture shown above, both red and
green indicators of Connector will light up.
3. When the battery is full charged, the red indicator of Connector will be off.
Turning On/Off Conceptronic Earbridge Headset
1. To turn on the Earbridge, press and hold S1 button for 3 seconds. You will hear two
short high tones and the blue indicator of Headset flashes.
2. To turn off the Earbridge, press and hold S1 button for 3 seconds. You will hear two low
tones and the red indicator flashes quickly. Then the Headset is powered off.
3. The red indicator of Earbridge will flash slowly when battery low.
Pairing Conceptronic Earbridge Headset
You are required to pair the Earbridge with your mobile phone or other devices before using it.
Step 1: The Headset must be powered off before initiating pairing. To initiate pairing, press
and hold S1 button for 5 seconds until the blue and red indicators of Headset are
flashing alternatively. If you are wearing the Headset during the pairing process, you
will hear two short high tones when the Headset is ready for pairing.
Step 2: Initiate pairing process of your mobile phone. Refer to the manual of mobile phone for
detail process. You will see a new item "Earbridge" added in your Bluetooth device list
after searching process.
Step 3: You will be asked to enter pin-code to complete pairing, enter 1234 and confirm it.
(Note: 1234 is the default pin-code pre-stored in the headset.)
The red indicator of the Earbridge will turn off and the blue indicator will flash slowly after
pairing completed successfully.