Publicité
Les langues disponibles
Les langues disponibles
OPERATION
The appliance is intended only for domestic use, not for professional use.
The following description is associated with the image on page 2:
1.
Lid insert
2.
Lid with safety-stop-function
3.
Filling opening
4.
Glass blender jug with handle
1.
Unpack the device and remove all packaging parts.
2.
Clean the jug kettle before using for the first time (see 'Cleaning and maintenance').
Operation
1.
Place the appliance on a flat, level surface.
2.
Put the blender jug (4) (with the handle on the right) on the motor unit (6).
3.
Fill the blender jug with the ingredients, and then add the liquid, where relevant (maximum 1 liter).
4.
Fit the lid (2) on the blender jug and turn it to the right until you hear a click sound.
5.
Now place the lid insert (1) into the filling opening (3).
6.
Turn the speed dial (7) to the required setting: P = Pulse, 0 = off, 1 = moderate, 2 = fast
7.
Whilst the blender is in operation you can add additional ingredients via the filling opening in the lid. First,
remove the cap from the lid opening. Then add the ingredients and close the lid opening with the cap.
8.
Switch off the blender (set to '0').
9.
Wait until the blender's knives have come to a complete standstill before removing the blender jug
from the motor unit.
WARNING:
•
The blender is fitted with a safeguard. The blender cannot be switched on if the blender jug is not fitted
to the motor unit, or is not fitted in the correct manner. This blender has a safety-stop-function which
causes the blades to automatically stop when the lid is opened.
Pulse mode
The Pulse setting can be used to operate the blender briefly at maximum speed.
CLEANING AND MAINTENANCE
1.
Disconnect from mains power supply.
2.
Clean the parts with soapy water, rinse and dry them thoroughly. Clean the motorhousing with a
damp cloth with soapy water and dry it thoroughly.
After every use
Clean the appliance and the seperate parts thoroughly after each use. Clean the mixing jug and blades
right after use, for the best cleaning results.
1.
Turn the speed dial to setting 0 (off)
2.
Fill the blender jug for ¼ with warm water.
3.
Turn the speed dial to setting 1.
4.
Switch off the blender after about 20 to 30 seconds ('0') and disconnect the plug from the wall socket.
The blades are clean now.
5.
Clean the motor unit with a damp cloth, if necessary moistened with a couple of drops of washing-up
liquid. After cleaning, dry the motor unit thoroughly.
WARNING:
•
Use only lukewarm water, hot water can cause cracks.
•
Never use ammonia or other products to descale the appliance. These can be injurious to your health.
Use solely a vinegar solution, or special descaling agents available from retailers.
SERVICE
If an unexpected problem occurs, please visit www.bestron.com/service for assistance.
5.
Blades unit
6.
Motor unit
7.
Speed dial
10
EN
Publicité
