LINDR PYGMY 20 Green Line new Mode D'emploi page 16

1. INTRODUCTION:
Thank you for purchasing this LINDR product.
2. DESCRIPTION OF THE COOLER:
This beverage dispensing system with built-in
compressor is designed for cooling, dispens-
ing and serving well-cooled beer and bever-
ages.
The modern Lindr compressor cooling unit
uses input energy and transforms it directly
into cooling, ensuring proper beer cooling at
minimum energy drain.
This manual is intended for models:
PYGMY 20 Green Line new
PYGMY 20/K Green Line new
PYGMY 25 Green Line new
PYGMY 25/K Green Line new
PYGMY 35/Kprofi Green Line new
KONTAKT 40 Green Line new
KONTAKT 40/K Green Line new
KONTAKT 40/Kprofi Green Line new
KONTAKT 70 Green Line new
KONTAKT 70/K Green Line new
16
KONTAKT 155 Green Line new
KONTAKT 155/K Green Line new
KONTAKT 155/R Green Line new
3. MACHINE PLATE:
4. GENERAL INSTRUCTIONS, MEASURES
AND SAFETY INSTRUCTIONS:
When using the device, follow basic safety
instructions stated by the manufacturer. The
cooling device is designed for flow-through
cooling of beverages. Any other use is consid-
ered impermissible and therefore dangerous.
The supplier is not liable for damage caused
by incorrect use.
DO NOT USE THE DEVICE FOR PURPOSES
OTHER THAN THOSE STATED BY THE MANU-
FACTURER!
The devices meet safety protection IP21.
General safety principles. Observe the fol-
lowing safety instructions.
The supplier is not liable for damage caused
by activities carried out on this device without
observing the following instructions!
WARNING: Children aged 15 or more and
persons with reduced physical, sensory or
mental capabilities or insufficient experience
and knowledge may only use the device when
supervised or instructed in safe use of the ap-
pliance and familiarised with potential dan-
gers.
WARNING: Children must not be allowed
to play with the appliance. Store all packaging
material out of reach of children (comes with a
plastic bag – suffocation hazard).
WARNING: Cleaning and maintenance of
the appliance on the part of the user must not
be done by unsupervised children.
WARNING: Before connecting to main elec-
trical supply, check that the voltage and fre-
quency in the mains corresponds to the data
stated on the device.
WARNING: Always make sure that the sock-
et you intend to plug the cooler into meets the
specifications on the machine plate (voltage,
frequency, input power).
WARNING: Before performing operations
on the device such as cleaning or maintenance,
ALWAYS disconnect the device from power
supply: set the thermostat to "O" position and
unplug the appliance from the socket.