Troubleshooting Guide; Ordering Replacement Parts - Ninja BL642 Guide Du Propriétaire

Troubleshooting Guide

PROBLEMS
Motor Doesn't Start or
Attachment Doesn't Rotate.
Food is Unevenly Chopped.
Food is Chopped Too Fine or is
Too Watery.
Food Collects On Lid or On the
Sides of the Container.
You Cannot Achieve Snow
From Solid Ice.
Motor Base Won't Stick to
Counter or Table Top.
You get an "Err" Message
You have a blinking red light
Replacement Parts

ORDERING REPLACEMENT PARTS

To order additional parts and attachments, please visit our website: www.ninjakitchen.com
or feel free to contact customer service: 1-877-646-5288.
18 1-877-646-5288
POSSIBLE REASONS & SOLUTIONS
Make sure the container is securely placed on motor base.
Make sure the lid is securely on container in the correct position (align
arrows).
The appliance is turned "Off". Press the power button ( ) to turn "On".
Check that the plug is securely inserted into the electrical outlet.
Check the fuse or circuit breaker.
The unit has overloaded. The appliance will stop and the power light will
flash. Unplug and wait approximately 15 minutes before using again.
The unit has overheated. Unplug and wait approximately 15 minutes before
using again.
Check to make sure the unit is not overloaded.
Either you are chopping too much food at one time, or the pieces are not of
even size and processing smaller amounts per batch.
The food has been over processed. Use AUTO-iQ
controlled processing.
The mixture is too thick. Add more liquid.
Do not use ice that has been sitting out or has started to melt. Use ice
straight from the freezer.
Start with a few pulses and then go to a continuous blending cycle.
Make sure surface and suction feet are wiped clean. Suction feet will only
stick to smooth surfaces. Suction feet WILL NOT stick on some surfaces
such as, wood, tile and non-polished finishes.
DO NOT attempt to use appliance when the motor base is stuck to a
surface that is not secure, (cutting board, platter, plates, etc.).
Your Ninja is able to detect which jar is on the base. You may be trying
to use a program that is not designed for the jar you have installed. The
programs will light up indicating which programs are available for each jar.
The unit is not installed properly. For your safety the unit will only be able to
be turned on when it is properly assembled. Please refer to the assembly
pages of this inspiration guide for assistance.
Pulse button for
™