Worx WG261 Mode D'emploi page 9

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
WARNING! DO NOT USE THE PRODUCT
WITHOUT ATTACHING THE GUARD AND
FRONT HANDLE.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the safe guard
Assembling the Front Handle
NOTE: Loosen the long screw first before
assembling the front handle.
NOTE: If the handle is assembled
incorrectly, the tool will not power on.
Installing and Removing the battery
pack
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use.
More details can be found in WA3742
manual
OPERATION
Starting and stopping
Top cutting
WARNING: If any parts are
missing, damaged or broken, do
not operate your hedge trimmer until all
damaged parts have been replaced or
repaired. Failure to do so could result in
serious personal injury. DO NOT USE
WITHOUT FRONT HANDLE AND SAFETY
GUARD.
Side cutting
Lubricating the Cutting Blade
Note: It is important to use only the
recommended standard lubricating oil
(WD-40) to avoid damage to the blade.
20V Max Lithium Cordless Hedge Trimmer EN
HOW TO USE YOUR HEDGE
TRIMMER
Note that the front switch lever can be activated
on three sides, giving you many choices for a
comfortable grip. Before cutting an area, inspect
it first and remove any foreign objects that could
become thrown or entangled in the blades. Always
hold the trimmer with both hands and with the blade
away from you before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
blade. (See Fig. E1& E2)
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
FIGURE
If the blade stalls, immediately stop the trimmer.
Release the two Switch components (5 & 6) before
attempting to clear jammed debris from the cutting
blades.
See Fig. A
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick for the
cutting blade.
See Fig. B1,
B2, B3
TOP CUTTING
Use a wide sweeping motion (See Fig. E1). A slight
downward tilt of the cutting blades in the direction of
motion gives the best cutting results.
See Fig. C
SIDE CUTTING
When trimming the sides of the hedge, begin at the
bottom and cut upwards (See Fig. E2), tapering the
hedge inward at the top. This shape will expose more
of the hedge, resulting in a more uniformed growth.
MAINTENANCE
See Fig. D1,
D2
Remove battery before carrying out any
adjustment, servicing or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
See Fig. E1
ventilation slots clean. Keep all working controls free
of dust.
See Fig. E2
See Fig. F
9