Description Of The Remote Control - Boost 12RGB-700 Manuel D'utilisation

EN
Description of the rear panel controls (see page 2)
1. Master volume control
2. BASS control: Adjustment of low frequencies
3. TREBLE control: Adjustment of high frequencies
4. Microphone volume control
5. Echo control for the microphone
6. Input for a wired mic (not supplied)
7. Switches the LED on the woofer on /off
8. When the power adaptor is connected, the indicator lamp will be lit a and the battery will charge
9. 12V battery input: please make sure to connect the external battery with the correct polarity (+ and -).
The cable section must not be smaller than 0.75mm².
10. AUX input via 3.5mm Jack
11. Input selector: Press this button to switch between the various inputs (AUX, USB, TF, Bluetooth)
12. REC button: Press this button to record the sound of the wired or wireless mic on the USB or SD.
13. REPEAT: Press to toggle between repeating the current track or repeating all tracks.
14. Press to go back to the previous track.
15. Play/pause in USB/TF/Bluetooth mode.
16. Press to go to the next track.
17. USB stick input
18. ON/OFF switch of the system
19. 15Vdc input connector
20. TF card input
21. Lights up when the LED light effect on the woofer is switched on

DESCRIPTION OF THE REMOTE CONTROL

1. MUTE: Mutes the sound output
2. Input selector: Press this button to switch between the various inputs (AUX, USB,
TF, Bluetooth)
3. REC: Press to record your voice
4. REC PLAY: Press to play your record
5. Increase the volume
6. Select previous file
7. Play/Pause/Select
8. Select next file
9. Reduce the volume
10. Repeat tracks / random play
11. Equalizer: Cycles through the various music styles: Normal – Rock – Classic – Jazz –
Pop
12. Number buttons for direct input of a file number. Press the number of the file to
access it directly. For files numbers above 9, press 1+ the unit. Ex. For file number
15, press 1 + 5. For file number 38, press 3+8
CONNECTION OF A WIRED MICROPHONE (not included)
Connect the microphone to the MIC IN socket and switch it on.
Note: If you are playing music from any other input, connecting the microphone will not mute the sound
output.
USING THE WIRELESS MICROPHONE
• Open the battery compartment and insert two AA batteries with the correct polarity.
• Turn the switch on the mic to ON. If the power indicator lamp doesn't flash or doesn't light up, check if the
battery has been properly inserted.
www.boost-sound.com
1
MUTE
2
3 4
5
REC
REC
PLAY
VOL+
6 8


SCAN
7
VOL-
9
10 11
12
5