Publicité
Les langues disponibles
Les langues disponibles
DRILL-ONLY MODE
To use drill-only mode, depress button
(D) and turn the dial so the yellow
arrow points to the corresponding
symbol as shown. Use drill-only mode
for wood, metal, and plastics.
HAMMER/DRILL MODE
To use hammer/drill mode, depress
the button and turn the dial so the
yellow arrow points to the corre-
sponding symbol as shown. Use this
mode for masonry drilling.
CHISEL ROTATION
To manually rotate the chisel, depress
the button and turn the dial so the yel-
low arrow points to the corresponding
symbol as shown.
HAMMER-ONLY MODE
For light chiseling, depress the button
and turn the dial so the yellow arrow
points to the corresponding symbol as
shown.
NOTE: The yellow arrow on the mode
selector MUST be aligned with the
one of the symbols at all times. There
are no operable positions between
the positions.
SDS Chuck (Fig. 4)
To insert bit, insert shank of bit about 3/4" into chuck. Push and rotate
bit until it locks in place. The bit will be securely held.
To release bit, pull the sleeve (D) back and remove the bit.
FIGURE 3
DRILL-ONLY
MODE
D
HAMMER/DRILL
MODE
CHISEL
ROTATION
D
HAMMER-ONLY
MODE
5
Operation
DRILLING
1. Always unplug the drill when attaching or changing bits or
accessories.
2. Use sharp drill bits only. For WOOD, use twist drill bits, spade bits,
power auger bits, or hole saws. For METAL, use steel twist drill
bits or hole saws. For MASONRY, such as brick, cement, cinder
block, etc., use carbide-tipped bits rated for percussion drilling. Be
sure the material to be drilled is anchored or clamped firmly. If
drilling thin material, use a wood "back-up" block to prevent dam-
age to the material.
3. Always apply pressure in a straight line with the bit. Use enough
pressure to keep drill biting, but do not push hard enough to stall
the motor or deflect the bit.
4. Hold tool firmly to control the twisting action of the drill.
5. IF DRILL STALLS, it is usually because it is being overloaded or
improperly used. RELEASE TRIGGER IMMEDIATELY, remove
drill bit from work, and determine cause of stalling. DO NOT
CLICK TRIGGER ON AND OFF IN AN ATTEMPT TO START A
STALLED DRILL — THIS CAN DAMAGE THE DRILL.
6. To minimize stalling or breaking through the material, reduce pres-
sure on drill and ease the bit through the last fractional part of the
hole.
7. Keep the motor running when pulling the bit back out of a drilled
hole. This will help prevent jamming.
8. With variable speed drills there is no need to center punch the
point to be drilled. Use a slow speed to start the hole and accel-
erate by squeezing the trigger harder when the hole is deep
enough to drill without the bit skipping out.
REMOVABLE SDS CHUCK & 3 JAW KEYLESS CHUCK
(D25304 ONLY)
The D25304 is equipped with a removable quick change SDS chuck
as well as a removable 3 jaw keyless chuck. The hammer mechanism
Publicité
