Krups PREP EXPERT S9000 Mode D'emploi page 17

• The appliance will start at once.
• Use the Pulse position (a2) for better control
of chopping.
With the mini-chopper (f) you can:
- in a few seconds, chop cloves of garlic,
mixed herbs, parsley, dried fruit, bread, rusk
for breadcrumbs, ham etc.,
- Prepare baby purées,
- Maximum quantity of dried fruit (hazelnuts,
almonds, etc.): 100g.
This mini-chopper is not designed for hard
products such as coffee.
With the grinder (g) you can:
- in a few seconds, chop coriander, pepper,
figs, dried apricots etc.
You can, for example, chop 100 g of dried
apricots in 5 seconds.
This grinder is not designed for hard products
such as coffee.
• To stop the appliance, turn the speed
control knob (a1) to 0.
• Wait for the appliance to come to a
standstill before removing the accessory by
turning it anti-clockwise and replace the cover
(a6) over the outlet (a5), turning it clockwise
to latch.
Cleaning
• Unplug the appliance.
• Never immerse the motor unit (a) in water
or put it under running water. Wipe it with a
dry or slightly damp cloth.
• For easier cleaning, quickly rinse the
accessories after use. Completely dismantle
the mixer attachment. Handle the blades
with care, as some have sharp cutting edges.
• Wash, rinse and wipe the accessories or they
can be put in the dishwasher (except for the
metal components of the mincer attachment
( body (e1), feed screw (e2), blade (e3), hole
plate (e4 and e5) and nut (e6)).
• The hole plates (e4) and (e5) and the blade
(e3) must be kept lubricated. Wipe them
over with cooking oil after each use.
• If your accessories are discoloured by food
(carrots, oranges etc.), rub them gently with
kitchen towel dipped in cooking oil and then
clean in the usual way.
hambourg Gb.PM6.5
• Blender assembly (d): pour hot water with a
few drops of washing up liquid into the
blender jug. Close the cover. Fit it on the
appliance and give a few pulses. Remove the
blender, rinse the jug under running water
and leave it upside down to dry. For cleaning
more difficult residues, especially with
thicker preparations, the blade nut assembly
can be detached from the bottom of the
jug. To do this, place the empty blender
upside down on a flat surface, release the
blade/nut assembly with a quarter turn and
lift out the seal with care.
What to do if your appliance
does not work
PROBLEM
The appliance
does not work.
Impossible to mix,
knead, beat,
emulsify or whisk
small quantities.
Abnormal noise.
The appliance
stops when
running.
21
CAUSES SOLUTIONS
The plug is not Connect the
inserted correctly: appliance to a
socket with the
correct voltage.
The cover (a6) or Check that the
accessory is not cover (a6) or
correctly positioned accessories are
on the multifunction correctly assembled
head (a4). and positioned.
The accessory is Adjust the height
too far from the of the accessory.
walls of the bowl. See paragraph:
Using your
appliance.
The cover (a6) or Check that the
accessory is not cover (a6) or
correctly positioned accessories are
on the multifunction correctly assembled
head (a4). and positioned.
The accessory is Adjust the height
touching the bottom of the accessory.
of the bowl. See paragraph:
Using your
appliance.
Quantity too large. Return the speed
control knob (a1)
to 0.
8/08/06, 13:52
21