Safety Device, Motor Overload; Safety Device, Motor Overheating; Safety Device, Access To Rotating Tools; Maintenance - EMGA 408.100 Mode D'emploi

Safety device, motor overload

Turn the power off (unplug the mains lead plug (10) before any work).
If the motor is jammed (17) (foreign body, too hard body, too much pressure on the
processed products, etc.) the switch (11) automatically goes to the 0 position. Rectify the
problem and then press the switch (11) to position 1.

Safety device, motor overheating

Turn the power off (unplug the mains lead plug (10) before any work).
If the motor overheats, the switch (11) automatically switches to the 0 position. Wait for the
motor to cool down (15 to 30 minutes) and then press the switch (11) to position 1.

Safety device, access to rotating tools

Tool access while operating safety is provided by the following three points:
1. The motor can only be started if the guide channel (2) is in position and locked by the
locking loop (3).
2. The guide channel provides safety on the input side for the products to be processed.
The dimensions of the introduction guide channel (2) comply with the standard safety
requirements currently in force.
3. The restriction system formed by the guide channel (2) and the ejector (12) provides
the safety on the output side of the products processed.

MAINTENANCE

!
Before any work on the appliance, it is imperative that the machine is
disconnected from the mains (10)

Spare parts:

This machine requires no specific maintenance. The bearings are lubricated for life.
If work is required to replace wear parts such as the electrical components or other, refer
to the parts list (see exploded view at the end of the manual).
For all spare part orders (see references in the exploded view at the end of the manual),
state:
 the type,
 the machine serial number and
 the electrical specifications
recorded under the machine.
98148 US 3.2 - 12 2010
408100-200 en ma 2010.12
9 / 14 www.santos.fr
9/14