Electrical Connection - EMGA 408.100 Mode D'emploi

ELECTRICAL CONNECTION:

 The electric power supply for the machine is available in 2 single-phase voltages:
- 110-120 V 50/60 Hz: model 48V1 and 49V1
- 220-240 V 50/60 Hz: model 48 and 49
Line protection: the machine should be connected to a standard 2-pole + earth electric
socket. The system should be fitted with a ground fault circuit interrupter and a fuse rated
at 16A. The appliance must be earthed.
CARE:
 Before connecting the machine, check that the mains electrical voltage
is the same as the voltage for your machine. This value is given:
!
 either on the identification plate under the machine.
 or on the identification plate on the last page of this manual.
 If the power supply lead is damaged, it must be by a special assembly available from
approved SANTOS dealers or from SANTOS.
Check that the On / Off switch (11) is in the 0 position before connecting the
CARE:
power supply lead plug to your mains electric power socket.
!
98148 US 3.2 - 12 2010
408100-200 en ma 2010.12
6 / 14 www.santos.fr
6/14