Maintenance; Fitting The Cutting Tool; Safety; Safety Device, Housing Closure - EMGA 408.100 Mode D'emploi

MAINTENANCE:

 Put the appliance to the "Off" position with the On/Off button (11) and unplug the power
supply lead plug (10).
 Remove the large diameter ram (5) or the reducer (6) and the small diameter ram (7).
 Unclip the locking loop (3) from the clip (4), pulling it towards you.
 Raise the guide channel (2). For cleaning after handling products which are difficult to
clean (products with greasy substances for example), the guide channel hinge pin (8)
can be removed and the guide channel washed in a dish washer.
 Take the disk (13, 14) off the motor spindle (18).
 Take the ejector (12) off the motor spindle (18).
 Wash with dish-washing detergent, then rinse and dry: the grater disk (13) or the slicer
disk (14), the guide channel (2) and the dirt tray (9).
 Clean the base (1) with a soft damp sponge and dry.

Fitting the cutting tool

FITTING:
 Fit the ejector (12), smooth side on the disk side, onto the end of the motor shaft (18), line the
grooves up with the pins (15) and push to the motor shaft stop (18).
 Fit the grater disk (13) or the slicer disk (14) lining up the drive pin with the groove in the disk
support (13) or (14).
REMOVING:
 Pull the grater-holder disk or the slicer disk upwards and along the motor shaft (18)
axis (be careful: risk of cuts on holding the tool, especially for the slicing disks
as the knife blades are very sharp).
 Pull the ejector (12) upwards and along the motor shaft (18) axis, making sure it
passes correctly level with the tool drive pin (15) on the motor shaft (18).

SAFETY

Safety device, housing closure

1. The guide channel (2) must be in the closed position and the locking loop (3) in the
locked position on the clip (4) to provide mechanical unlocking of the motor and allow
the slicer to be turned on with the On/Off switch (11).
2. Unclipping the locking loop (3) causes stoppage (position 0) on the switch (11) and
mechanical stoppage of the motor spindle (18).
3. A cut in the mains power supply causes stoppage (position 0) on the switch (11). The
switch (11) has to be reactivated (position 1) to start again.
98148 US 3.2 - 12 2010
408100-200 en ma 2010.12
8 / 14 www.santos.fr
8/14