Audio Pro Business SP-1 Manuel D'utilisation page 4

ENGLISH
GENERAL INSTALLATION NOTES
•
NETWORK OVERVIEW
•
APB PRODUCT RANGE
•
WIRELESS INSTALLATION
•
WIRELESS + WIRED INSTALLATION
•
TROUBLESHOOTING
•
NOTE: Installations examples on last pages in manual.
GENERAL INSTALLATIONS NOTES
• Always try to have the TX-1 transmitter placed in the
"middle" of the installation and at the same height as
the SP-1, SP-3 speakers are placed.
• If the source is placed far away from the TX-1 it is
possible to use an active USB extender cable (normally
available up to 20m) to achieve best possible placement
of the TX-1.
• The VOL-1 should ideally also be placed in the same
height as the TX-1 and SP-1, SP-3.
• The SP-1, SP-3 and SUB-1, SUB-3 in wired mode uses
a balanced audio signal so a cable with 3 conductors
(+,g,-)are necessary to make the installation.
PAIRING
There can be a maximum of 31 units in one setup.
When pairing, the TX-1 is open for 20 minutes more every-
time you pair a new unit.
For more technical specifications, visit www.audioprobusiness.com
4
FEATURES
• 6 volume zones
• No time delay
• RF band 1.9 GHz
• Range 20–100 m
• Be aware that it is only possible to go from a wireless
speaker and then continue with wired installation. It is
not possible to go from wired speaker and then make it
wireless to the next speaker in line.
• In wireless mode the SUB-1, SUB-2 subwoofer can be put
on a separate zone volume, making it is easy to match
the subwoofer volume to the rest of the system.
VOLUME ZONES A–F
Each VOL-1 can have up to 6 different volume zones (A-F).
Individuallly set volume in each zone. Master volume controls
all zones.
C
D
A
E
A
B
C