Product Installation; Checklist Before Product Installation - RICHWAY BIOMAT Mini 7000mx Manuel De I'utilisateur

Product installation

Checklist before product installation

• Do not use the product in areas with high humidity or significant dust.
• Handle the Biomat with care. Any physical impact such as dropping the Biomat can damage internal
components.
• Check the voltage before turning on the Biomat.
▪ Voltage for the product: 120V
▪ Electric shock or damage to the Biomat can result from improper voltage.
▪ The Biomat and the controller must be the same voltage.
(i.e. 120V Biomat + 120V Controller / 220V Biomat + 220V Controller)
• Do not use the Biomat if the plug, power cable, or power outlet has any damage. Always check for
cuts and scrapes to the power cable.
• Do not pull on the power cord or controller when unplugging the Biomat.
• Use a dedicated outlet when operating the Biomat. Problems may occur when sharing a power strip
with other devices.
Product installation
To operate the Biomat follow the steps below.
Lay the Biomat on a flat surface with the ridges facing up. Any uneven surface can damage the
1.
Biomat. The Biomat can bend 90° to 138°.
2.
Connect the controller / power cable to the connection port of the Biomat. To ensure a secure
connection, there should be no space between the connector and the outlet on the mat.
The connection may be tight at first.
NOTE: Use care when handling the controller / power cable to prevent accidental breakage. Do
not drop, stand on or place heavy objects on the controller / power cable. Never pull the
power cable to remove the plug from the receptacle, be sure to hold the plug.
<IMPROPER CONNECTION>
3.
Plug the controller / power cable into an outlet. Make sure the controller is rated for the same
voltage as the outlet.
11
<PROPER CONNECTION>