Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Step 5: Installing the supply Fitting
Use the 2557-1 supply fitting if the water supply pipe under the sink attaches
to a 3/8" flex pipe from the kitchen faucet. If your piping is different or if you
do not have a shut-off valve under the sink, you can order Rainfresh CK514
or CKT14 valves (depending upon your piping) directly from
www.rainfreshstore.ca
IMPORTANT: Before you install supply fitting, confirm the cold water pipe by
running hot water through your kitchen faucet and touching both pipes.
Now turn off the
cold water supply
valve to the kitchen
faucet.
Now connect the other end of the supply tubing to the INLET fitting of the filter
head
by pushing the tube into the fitting until it touches the tube stop and cannot go in
any further (Fig 7)
Step 6: Start up
Reconnect QCA cartridge on the head below the inlet fitting (left side of unit) and
QLV cartridge on the other head (right side of unit), (lock position) (see Fig 8).
Turn the faucet handle to ON position.
Turn saddle valve handle clockwise. After some free rotations, the needle on the valve will start to pierce
the pipe. Continue to rotate the handle until it can go no further. You have now pierced the pipe, but
the valve is closed. Now turn handle counter clockwise all the way to open and start water flow.
Close faucet and check all connections for leaks. Carefully retighten any leaking fittings. It is a good idea
to check the unit a few times for slow leaks shortly after installation.
Flushing and conditioning: Allow water to flow from the faucet for 10 minutes to flush unit before
beginning service. Note: Some carbon fines may persist for several days and the water may also appear
milky because of trapped air bubbles coming out of the unit. These are harmless and frequent running
of the unit will clear them more quickly. Running the unit for extended periods of time will NOT help.
YOUR UNIT IS NOW IN OPERATION.
Using a wrench,
unscrew the faucet
tube from the
supply valve.
Thread in the 2557-1
supply adapter &
then attach the
faucet tube to it.
CKT14
CK514
3/8"x3/8"x1/4"
½"x½"x1/4"
TO
FILTER
INLET
Push the leftover ¼"
tubing into the supply
adapter until it touches the
tube stop and cannot go
in any further.
FIG 7
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Twist qs2x

Table des Matières