Installation; Mounting The Faucet - Rainfresh Twist QS2 Mode D'emploi

(D) INSTALLATION
Installation shall comply with applicable state and local regulations

TOOLS REQUIRED: Drill, ½" drill bit, Philips & flat-head screwdrivers, adjustable wrench, marker or pencil, a
sharp knife and measuring tape.
Unpacking the unit
The following items are included in the box:
Filter unit with QCA
& QLV cartridges +
Monitor
(QS2 only)
Remove both cartridges (QCA & QLV) by turning it 1/4 turn left, then pulling away from head assembly (see
Fig 8). Place it aside in a safe place until final assembly.
The following instructions are for installing the TWIST system under the sink. It can also be installed on any
other wall mounted remote location (such as basement or crawl space) from where tubing can be run to the
faucet. The unit should not be installed more than fifteen feet away from the faucet. Call Rainfresh if you have
questions.
Step 1: Mounting the Faucet
Note: Faucet may be installed in an existing
hole in sink if available or in counter top.
1. Position faucet on counter top beside
sink in desired position. Ensure that
swivel spout will extend over sink and
that there is room under the counter for
faucet shank and to tighten nuts.
2. Mark the location and drill a ½" hole
(Fig 2). Protect your counter top by applying a layer of
masking tape and use a sharp drill.
attempt to drill a hole yourself in marble, granite or
engineered stone as it can result in damage to the
countertops.
3. Insert faucet shank through escutcheon washer (1050-10),
and then through counter top (See Fig. 3). Install plastic
locating washer (1050-12), lock washer (1050-13) and
locking nut (1050-14). Tighten locking nut securely while
someone holds the faucet body so it does not turn.
1050-10 -
1050-11-
1050-12 (hard) -
1050-13-
1050
Faucet
1050-14-
Fig 2
Caution:
1
1
2557-1
1
Supply adapter
fitting
1
1
Insert Sleeve
1603 1008-3
Do not
2545
CR2032 battery
(Model QS2 only)
1011-0
Mounting ¼" OD tubing
Nut
Screws (3)
726-0
2730
(6 ft)
Fig 3
3