Mounting The Unit; Connecting The Faucet - Rainfresh Twist QS2 Mode D'emploi

Step 2: Install battery (For model QS2 only)
Before mounting the unit, install the monitor battery.
Remove head cover insert (2718) by gently pulling away
the insert from the head. Unwrap coin battery (2545) and
2718
insert into battery slot between contacts with + side out.
Do not reattach the head cover insert yet.
Step 3: Mounting the Unit
Locate best position for mounting unit undersink near faucet. The higher and closer to the front you mount the
unit the easier it will be for regular maintenance (see Fig 1). There are 3 mounting bracket screw locations – 2
located on the bottom of the head cover and 1 is located at the center between the two filter heads.
Note: Screw holes at bottom should be at least 12 inches up from the base of the cabinet (you must
allow at least 3 inches of clearance below the cartridges for easy removal).
Screw in the 3 screws making sure that the head assembly is level. Note: If wall is too thin to accept screw then
use round head nuts and bolts (not supplied) to mount head assembly. For model QS2, now re-attach the head
cover insert (2718), carefully aligning it so that the black button on the monitor lines up through the hole on the
cover insert.
Step 4: Connecting the faucet
Measure the tubing required to connect faucet to the white OUTLET
Acculink™ fitting (arrow pointing away from the fitting) and cut this
length from the tubing supplied. Make a straight cut as shown in Fig 4.
FIG 4
Note: Use only a sharp knife to cut the tube straight.
Warning: Angled or rough cuts can cause a water leak. Leave the rest
of the tubing for the supply water connection.
Slide compression nut (726-0) and compression sleeve (1008-3) onto
tube and put tube insert (1603) into tube as shown in Fig. 5. Now tighten
nut securely with a wrench.
Identify the INLET & OUTLET of the unit (Fig 6A). Connect the other end
TM
of tubing to OUTLET Acculink fitting by pushing the tube into the
fitting until it touches the tube stop and cannot go in any further
(Fig. 6B). Pull tube to confirm secure connection. Note: To remove tubing
from the fitting, press the collet in with two fingers while pulling tube out
Fig 6C). Without pressing the collet, the tubing will stay locked in
FIG 5
position.
FIG 6C
FIG 6A
FIG 6B
4