Installing Your Deep Freeze And First Operation - Edy EDHV7054 Mode D'emploi

3. SECTION

INSTALLING YOUR DEEP FREEZE AND FIRST OPERATION

1. Remove plastic transport supports between the door and the body.
2. Air circulation should be ensured at the rear area of the deep
freeze for efficient use. At least 20 cm gap should be allowed at lateral
and rear sides of your deep freeze.
3. Do not expose the product to direct sunlight or keep in damp en-
vironments.
4. Place the product on a flat surface to avoid vibration.
5. If you operate your deep freeze in conditions below 10°C or over
43°C, the functionality may not be at the desired level.
6. After completing installation, allow at least 2 hours without mov-
ing your product. Then, plug it into plug socket.
Electrical Connection
• Our firm will not assume responsibility for any damages due to us-
age without earthing and power connection in
compliance with national regulations.
• Do not use multi-group plug with or without extension cable between the
wall socket and the refrigerator.
• Connect your refrigerator to a 220-240V /50 Hz grounded mains socket.
The socket must include a 10-16A fuse.
The voltage and frequency of mains power should be the
!
same as the values specified on the label behind your appli-
ance. If mains power is far below or above the specified value,
have the desired voltage by using a voltage regulator. You can get
help from a qualified electrician. The fuse of the mains socket should
be maximum 16A.
11