CAMPAGNOLA 58.8V/2.5A Mode D'emploi page 5

Operation
1. Before first use please check the parameters of the charger and your battery according the
rating label or the manual to ensure the compatibility.
2. Check if the local main AC voltage level is suitable for the charger.
AC input voltage
3. For a function test plug the mains cable into an AC mains socket. The green LED will flash
slowly, this indicates stand by.
4. Now connect the DC cable to the battery pack. The green LED will flash equally and shows
that charging is started. The red LED indicates a battery error.
5. If the battery pack is fully charged the charger will cut off. The green LED will be turned on
steady, this indicates a fully charged state.
Status
Stand by
Charge
Battery full
Error
Charge end voltage 58.8V +/-1%
Remarks
This charger has a polarity protection. Only with the correct polarity the charger can generate a
charge voltage. Depending on the battery safety board, a battery pack which is discharged under
its minimum discharge voltage cannot be charged again. In this case please contact your battery
supplier.
Nominal
100V – 240V
LED Indicators
LED red
off
off
off
flash
LED green
Slow flash 10% on
Flash 50% on
Steady on
Off