Bosch GMR 1 Professional Notice Originale page 9

OBJ_BUCH-255-003.book Page 9 Wednesday, April 22, 2009 10:18 AM
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.
Functional Description
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The machine is intended for routing grooves,
edges, profiles and elongated holes as well as
for copy routing in wood, plastic and light build-
ing materials, while resting firmly on the work-
piece.
Bosch Power Tools
All manuals and user guides at all-guides.com
Product Features
The numbering of the components shown refers
to the representation of the power tool on the
graphic pages.
1 Motor unit
2 Routing base
3 Thumbwheel for depth-of-cut fine adjust-
4 Router bit*
5 Tightening nut with collet
6 Guide plate
7 Base plate
8 Scale for depth-of-cut
9 Spindle lock button
10 Clamping lever
11 On/Off switch
12 Collet chuck
13 Tool holder
14 Open-end spanner (17 mm)
15 Base cover sleeve
16 Guide bushing*
17 Parallel guide
18 Wing bolt for attachment of side stop
19 Wing bolt for parallel guide
20 Roller guide *
21 Roller
22 Wing bolt for locking of the horizontal align-
23 Wing bolt for horizontal alignment of the
24 Nut for adjustment of the tensioning force
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
ment
ment
roller guide
2 609 140 653 | (22.4.09)
English | 9