Bosch GMR 1 Professional Notice Originale page 12

OBJ_BUCH-255-003.book Page 12 Wednesday, April 22, 2009 10:18 AM
12 | English
Operation
Adjusting the Depth-of-cut
(see figure F)
The adjustment of the depth-of-cut may on-
ly be carried out when the router is
switched off.
For coarse adjustment of the depth-of-cut, pro-
ceed as follows:
– Place the machine with the router bit mount-
ed on the workpiece to be machined.
– Open the clamping lever 10 on the motor unit
if locked.
– Turn the routing base 2 so that the
points against the symbol and slowly
lower the motor unit until the router bit
touches the workpiece.
– Lock the clamping lever.
– Read the measuring value off the scale 8 and
note it down (zeroing). Add the desired
depth-of-cut to this value.
– Open the clamping lever and adjust the mo-
tor unit to the calculated scale value.
– Turn the routing base so that the
points against the symbol and lock the
clamping lever again.
– Check the carried out depth-of-cut adjust-
ment with a trial cut and correct it, if neces-
sary.
For fine adjustment of the depth-of-cut, proceed
as follows:
– With the clamping lever 10 open, turn the
routing base so that the
against the symbol.
– Adjust the desired depth-of-cut with thumb-
wheel 3.
– Lock the clamping lever.
2 609 140 653 | (22.4.09)
All manuals and user guides at all-guides.com
Starting Operation
Switching On and Off
To start the machine, set the On/Off switch 11
to I.
To switch off the machine, set the On/Off
switch 11 to 0.
Working Advice
mark
Direction of Feed and Routing Process
(see figure G)
mark
Note: Take into consideration that the router bit
4 always extends out of the base plate 7. Do not
mark points
damage the template or the workpiece.
– Set the desired depth-of-cut (see "Adjusting
– Switch the machine on and guide it to the lo-
– Carry out the routing process applying uni-
– Switch the machine off after finishing the
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Protect router bits against shock and im-
pact.
The feed motion of the router bit 4 must al-
ways be carried out against the rotation di-
rection of the router bit (up-grinding).
When routing in the rotation direction of the
router bit (down-cutting), the machine can
break loose, eliminating control by the user.
Use the machine only with the routing base
2 mounted. Loss of control over the machine
can cause injuries.
Before beginning the routing procedure,
check if the mark on the routing base is
positioned in line with the
motor unit 1.
the Depth-of-cut", page 12).
cation subject to working.
form feed.
routing process.
Do not place the power tool down until af-
ter the router bit has come to a complete
stop. Coasting application tools can cause
injuries.
symbol on the
Bosch Power Tools