Publicité
Slide the whole thing as far as possible to the rear.See figure 3
For dismantling and fitting the vehicle parts, see the site handbook.
For fitting instructions and attachment method, see drawing.
NOTE:
* Should this installation process entail the cutting of the bumper –
conformation MUST be obtained by the installation engineer of the
customer's acceptance prior to completion. Brink Towing Systems do
not accept responsibility for any matters arising as a result of this
miscommunication.
* All measurements are in mm!
D
MONTAGEANLEITUNG:
Vor Beginn des Einbaus ist anhand der Typplakette der Anhänger-
kupplung festzustellen, welche Einbauskizze in dieser Montagean-
leitung die richtige ist.
Das Ganze so weit wie möglich nach hinten schieben.Siehe
Abbildung 3
Publicité
