SAMES KREMLIN PRIMA 01D100 Manuel D'utilisation page 102

DocuSign Envelope ID: E5F0A3D0-A8AB-46B7-B12A-B6AAD9ACBE7A
SAMES KREMLIN SAS
13, chemin de Malacher
38 240 - MEYLAN - FRANCE
Tél. : 33 (0)4 76 41 60 60
(1) The manufacturer herewith declares that the equipment Is in conformity with the UK statutory requirements.
(2) Equipment type
Applicable Directives
(3)
(9) Approved body
(10) This partly completed machinery must not be put into service until the final machinery in which it is to be
incorporated has been declared in conformity with Supply of Machinery (Safety) Regulations 2008. SAMES KREMLIN is
allowed to compil the technical documentation. SAMES KREMLIN undertakes to transmit, in response to a reasoned
request by the national authorities, relevant information on the partly completed machinery in the most appropriate
form. This declaration of incorporation of partly completed machinery and this declaration of conformity are issued
under the sole responsibility of the manufacturer.
Director of the STAINS site - Executive Management (EM)
Hervé WALTER
Established in Stains, on
Document reference – DEC-578154130-01D100-UKCA-A
Pompe pneumatique à membrane / Pneumatic diaphragm pump
The essential health and safety requirements mentioned in Supply of Machinery
2008 No. 1597
(Safety) Regulations 2008 have been applied.
Articles: 1.1 , 1.1.2 ,1.1.3, 1.1.5 , 1.2 , 1.2.2, 1.2.3, 1.2.4, 1.2.4.1 , 1.2.4.3 , 1.2.6, 1.3 ,1.3.1,
1.3.2, 1.3.3, 1.3.4, 1.3.6, 1.3.7, 1.5, 1.5.2, 1.5.3, 1.5.4, 1.5.5, 1.5.6, 1.5.7, 1.5.8, 1.6, 1.6.1 ,
1.6.2, 1.6.3, 1.6.4, 1.7, 1.7.1, 1.7.2
(5) That partly completed machinery is also in conformity with the provisions of
- Conditions spéciales d'utilisation, le signe X indique de se référer aux prescriptions
2016 No. 1107
figurant dans le manuel d'instructions qui accompagent le produit.
- Specific conditions of use, "X" indicates to refer to the prescriptions specified in the
instructions manual that accompanies the product.
(7) Designated standards
(8) Conformity assessment procedure
CML 25031 – Ellesmere Port – United Kingdom / CML N° :
15-abr-22 | 05:51 BRT
DECLARATION OF INCORPORATION
OF PARTLY COMPLETED MACHINERY
UK DECLARATION OF CONFORMITY
PRIMA 01D100
TM
(4) The relevant technical documentation was compiled
as specified in annex VII, part B.
(6) Marking
Pump
II 2G Ex h IIB T6 Gb X
Ex h => Protection par sécurité de
construction (c) / Protection by
constructional safety (c)
EN ISO 80079-36 : 2016
EN ISO 80079-37 : 2016
EN 1127-1 : 2019
Module A Technical documentation
(Annex VIII)
Page 1 of 2