SAMES KREMLIN PRIMA 01D100 Manuel D'utilisation page 100

DocuSign Envelope ID: 89778BBF-8DB7-4F6D-B453-C2C4DC640FE2
SAMES KREMLIN SAS
13, chemin de Malacher
38 240 - MEYLAN - FRANCE
Tél. : 33 (0)4 76 41 60 60
(1) The manufacturer herewith declares that the equipment is in conformity with the relevant Union harmonization legislation.
(2) Equipment type
(3) Applicable Directives
(9) Notified body
(10) This partly completed machinery must not be put into service until the final machinery in which it is to be incorporated has
been declared in conformity with Directive 2006/42/CE on Machinery. SAMES KREMLIN is allowed to compil the technical
documentation. SAMES KREMLIN undertakes to transmit, in response to a reasoned request by the national authorities, relevant
information on the partly completed machinery in the most appropriate form. This declaration of incorporation
of partly completed machinery and this declaration of conformity are issued under the sole responsibility of the manufacturer.
Director of the STAINS site - Executive Management (EM)
Hervé WALTER
Established in Stains, on
07-avr.-22 | 13:29 CEST
Document reference – DEC-578154130-01D100-EU-A
Pompe pneumatique à membrane / Pneumatic diaphragm pump
(4)
The essential health and safety requirements mentioned in the Directive 2006/42/CE
2006/42/CE
on Machinery have been applied.
Articles: 1.1 , 1.1.2 ,1.1.3, 1.1.5 , 1.2 , 1.2.2, 1.2.3, 1.2.4, 1.2.4.1 , 1.2.4.3 , 1.2.6, 1.3 ,1.3.1,
1.3.2, 1.3.3, 1.3.4, 1.3.6, 1.3.7, 1.5, 1.5.2, 1.5.3, 1.5.4, 1.5.5, 1.5.6, 1.5.7, 1.5.8, 1.6, 1.6.1 ,
1.6.2, 1.6.3, 1.6.4, 1.7, 1.7.1, 1.7.2
(5) That partly completed machinery is also in conformity with the provisions of
- Conditions spéciales d'utilisation, le signe X indique de se référer aux prescriptions
2014/34/UE
figurant dans le manuel d'instructions qui accompagent le produit.
- Specific conditions of use, "X" indicates to refer to the prescriptions specified
in the instructions manual that accompanies the product.
(7) Harmonised standards
(8) Conformity assessment procedure
INERIS 0080 – 60550 Verneuil-en-Halatte -France / N° INERIS :
DECLARATION OF INCORPORATION
OF PARTLY COMPLETED MACHINERY
EU DECLARATION OF CONFORMITY
PRIMA 01D100
TM
The relevant technical documentation was compiled
as specified in annex VII, part B.
(6) Marking
Pump
II 2G Ex h IIB T6 Gb X
Ex h => Protection par sécurité de
construction (c) / Protection by
constructional safety (c)
EN ISO 80079-36 : 2016
EN ISO 80079-37 : 2016
EN 1127-1 : 2019
Module A Technical documentation
(Annex VIII)
Page 1 of 2