Completing The Installation - Haier ESAQ406P Guide D'utilisation Et D'entretien

COMPLETING THE INSTALLATION

ATTACH SIDE CURTAINS TO WINDOW
1. Pull the right-hand curtain and frame out until it fits flush to the side of
the window frame. See ig.
2. Use a 1/8" drill bit to drill a starter hole through the top hole in the side
curtain and into the window sash.
curtain and into the window sash. See ig. 8
4. Repeat for the left-hand curtain.
5. Use a 1/8" drill bit to drill a starter hole into the window sill using the
bottom hole in the side curtain as a guide.
the right-hand curtain and into the window sill. See ig.
7. Repeat for the left-hand curtain.
FINAL INSTALLATION
1. Uncoil the included foam seal. See ig. 0
2. Insert the foam seal behind the top of the lower window sash
and against the glass of the upper window.
3. Place the window lock bracket as shown in the diagram using
a screwdriver. Use a 1/8" drill bit to drill a starter hole through the
hole in the window lock bracket and into the upper window.
See ig.
1" wood screw to secure the unit in place.
5. Plug unit into a grounded 3 prong outlet.
6. Press RESET on the power supply cord on some devices.
A green light will come on. See "Electrical Requirements"
for full detail.
HOW TO INSTALL
Fig. 17
Fig. 18
Fig. 19
Fig. 20
Fig. 21
PAGE 13