Publicité
Les langues disponibles
Les langues disponibles
General operation
Cassette playback:
Stop and ejection:
Fast forward:
Remark
•
Make sure the direction is correct when inserting the tape into the system.
•
There is some searching noise can be heard and the system cannot perform normal playback
function during fast forward mode.
•
This is recommended to take out the cassette tape from the system every times after listening
and don't leave the cassette tape inside the system when not under playback mode.
noted:
-
Remove the stylus protector.
-
Be sure that the tone arm is being detached from the tone arm rest before operating and re-secured
again afterwards.
1. Select to " Phono " function (15).
2. Set the speed selector to the proper position depending on the record to be played.
3. Place the record on the platter (use the spindle adaptor if required).
4. Lift the tone arm from the rest and slowly move it to the record side. The platter will start to rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the volume to the desired level.
Listing to Tape
The system will start the playback automatically after inserting of cassette
tape.
Press the " Tape forward / eject " button (23) completely inwards and the
cassette tape will be ejected though the cassette door cover (24). The " Tape
forward / eject " button (23) will keeping at lowest height position.
Press the " Tape forward / eject " button (23) half inwards during Playback
mode, the tape winding forward direction. The " Tape forward / eject " button
(23) will keeping at middle height position.
Slightly press the " Tape forward / eject " button (23) again to resume normal
playback. The " Tape forward / eject " button (23) will resume to the highest
position.
Phono
18
Publicité
