Kenwood NEXEDGE NXR-710 Manuel D'instructions page 2

CONTROLS AND FUNCTIONS
■ Front Panel
a Speaker
b CH/STATUS Display
Two 7-segment digits display the channel number, name,
or status.
c VOLUME control
Rotate to adjust the audio.
d POWER switch
e POWER indicator
Lights green when power is supplied to the DC 13.2V jack.
■ Rear Panel
TEST/SPKR
a TX OUT jack
Connect a TX antenna or a duplexer to this receptacle.
b CONTROL I/O jack
Connect a repeater controller or a remote panel to this
DB-25 interface.
c REF IN jack
Connect to a 10 MHz external oscillator.
d RX IN jack
Connect an RX antenna or a duplexer to this BNC
receptacle.
e FUSE
Insert 15 A blade fuse into this fuse holder.
REPEATER OPERATION
Note:
◆ Please consult your dealer for programming the repeater.
◆ After switching the power on, the CH/STATUS display blinks for
approximately 30 seconds, until the internal circuit stabilizes. Wait
until the display remains lit, before operating.
When power is applied to the unit, the POWER indicator lights:
・ Green when using the DC jack.
Rotate the VOLUME control to adjust the audio.
The BUSY indicator lights green while receiving a signal and the
TX indicator lights red while transmitting.
a
b
TX OUT CONTROL
I / O
h
a
f MIC jack
Connect a microphone to this 8-pin modular jack.
g Programmable Function keys
Press these keys to activate their programmable functions.
h BUSY indicator
Lights green while a signal is being received.
i TX indicator
Lights red while transmitting.
d e
c
REF IN RX IN
FUSE 15A
DC 13.2V
N S Y N C
g f
f DC 13.2V jack
Connect a 13.2 V DC power supply to this jack.
g N SYNC 1 / 2 jack
Conventional IP : Connect KTI-3 (Network Interface Unit).
Type-D Trunking : Connect each repeater with optional
(N-SYNC cable) : E30-7701-XX (20 cm/0.7 ft) or
h TEST/SPKR jack
Test input/output jack. Connect an external speaker to
this jack.
When using a Built-in speaker, connect the attached Lead
wire with connector (15 pin) to this jack.
TRANSCEIVER OPERATION
■ Receive
Adjust the volume to your desired level. You may need to
readjust the volume if you are having interference while
receiving a message from your dispatcher or another member
in your fleet.
The BUSY indicator lights green while a signal is being
received.
■ Transmit
1 Listen to the channel before transmitting, to make sure it
is not being used.
2 Press the microphone PTT switch, then speak in your
normal speaking voice.
The TX indicator lights red while transmitting.
3 When you finish speaking, release the PTT switch.
2
b c d
e
CH/STATUS
VOLUME
POWER
BUSY
TX
MIC
i h g f
N-SYNC cable.
E30-7717-XX (1 m/ 3.3 ft)