Télécharger Imprimer la page

V2 HEAVY2 Mode D'emploi page 41

Publicité

Les langues disponibles

Les langues disponibles

18 - ENCODER
The position of the door can be detected much more accurately if
an incremental decoder is mounted on the motor.
m
WARNING: It is essential to run the learning phase of
the travel (chapter 25.3) to use this feature
NOTE: The encoder uses the same terminals of the switches for
the intermediate positions. If you are using an encoder you cannot
use the switches for intermediate positions.
It is possible to use two types of encoder:
• Two-channel encoder: the direction of movement of the door
is indicated by the encoder itself.
- Connect the two channels on terminals H3 and H4
(the connection order is not important)
- Connect the common on the terminal H5
- Set the menu
on
ENCO
• One-channel encoder: the direction of movement is
determined by the command given to the motor through the
unit.
- Connect the channel of the encoder on terminal H4
- Connect the common on the terminal H5
- Set the menu
on
ENCO
If the encoder is powered to 24Vac connect the power supply to
terminals E1 and E3.
If the encoder is powered to 12Vdc connect the power supply to
terminals H7 (-) and H8 (+).
* NOTE: if the encoder has a single wire for the negative pole
of the power supply and the common of outputs, connect the
terminal H5 to the negative pole of the power supply
(terminal H7 or one of the terminals E1-E3)
EN.2C
EN.1C
H1H2 H3 H4 H5 H6 H7 H8 E1 E2 E3 E4 E5
ENCODER
2C
H1H2 H3 H4 H5 H6 H7 H8 E1 E2 E3 E4 E5
ENCODER
2C
H1H2 H3 H4 H5 H6 H7 H8 E1 E2 E3 E4 E5
ENCODER
1C
H1H2 H3 H4 H5 H6 H7 H8 E1 E2 E3 E4 E5
ENCODER
1C
parameter
ENCO
- 39 -
24Vac
-
12Vdc
+
24Vac
-
12Vdc
+
a
DEFAULT =
(no function)
NO

Publicité

loading