Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TROUBLE SHOOTING
If your heater fails to operate, please follow these instructions:
•
Ensure that your circuit breaker or fuse is working properly.
•
Be sure the heater is plugged in and that the electrical outlet is working
properly.
•
Check for any obstruction. lf you find any obstruction, turn the heater
"OFF". Unplug the heater and wait a few minutes for it to cool down.
Carefully remove the obstruction. Plug the heater in and turn it on again
by referring to the OPERATING INSTRUCTIONS.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE
SEE THE WARRANTY INFORMATION FOR INSTRUCTIONS. PLEASE DO NOT
ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF. DOING SO MAY
VOID THE WARRANTY AND COULD CAUSE DAMAGE OR PERSONAL INJURY.
IF THE PROBLEM STILL PERSISTS, PLEASE CONTACT US BY REFERRING
TO THE SERVICE & SUPPORT INFORMATION ON THE FOLLOWING PAGE.
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least one time during the
operating season in order to provide the optimum level of performance.
ALWAYS TURN THE POWER SWITCH OFF AND UNPLUG THE HEATER
BEFORE CLEANING.
Be sure to save the box for off-season storage.
•
Turn the heater" OFF", unplug it and wait for the heater to cool down.
•
Use a dry cloth to clean only external surfaces of the heater.
•
Do not use any cleaning agents or detergents.
•
Never immerse the heater in water.
•
Pack the heater in the original carton and store it in a cool and dry place.
SPECIFICATIONS
Model No.: NT15-13L (LLR33558)
Voltage: 120V, 60Hz
Current: Maximum continuous draw: 12.5 Amps.
Output: 5200 BTUs
Power: LOW=900 Watts, HIGH=1500 Watts
Tolerances on all specifications: Approximately +5%,-10%
4
Publicité
Table des Matières
