Beamz S1500 DMX Manuel D'instructions page 4

DIP 8
DIP 7
233 DIP 6
DIP 4
DIP 1
CHANNEL VALUE
0 – 100%
1
Note:
It is necessary always lock a DMX loop with a 120 Ohm terminator for correct data transmission.
Maintenance
Refilling the fluid reservoir should be done carefully. Remove the plug from the mains first! Then unscrew the
cap of the reservoir and fill it by means of a suitable funnel. Use only the original Beamz smoke liquid. This
fluid is environmentally friendly, biodegradable and leaves no residue when used correctly. Make sure the
smoke liquid to become contaminated, close the cap of the liquid smoke can and after filling tank right.
After 40 hours, the smoke machine must be cleaned to avoid deposits in the machine, pump and
heater. Clean procedure: Run clean procedure in a well-ventilated area
•
Remove smoke liquid from the tank, add cleaning solution to tank
•
Switch smoke machine and wait until it is warm up
•
Press the button to switch the liquid pumped through the machine
•
Perform the above operation until the tank is empty
•
Fill the tank with liquid smoke
Specifications
Power supply: ....................................................
220-240V~/50Hz
element: ......................................................... 1500
watts
time: .................................................................
minutes
Continuous use: ..................................................... Max. 1 minute
Smoke production: ......................................... ca. 295
m3/minute Tank
capacity: ............................................................... ca 2
liters
Dims: ............................................................ 465 x 310 x 210mm
Weight ................................................................................ 5.6 kg
128
64
32
8
1 (128+64+32+8+1
=233)
FUNCTION
Smoke level
Heating
Heat up
8