Télécharger Imprimer la page

Beamz S1500 DMX Manuel D'instructions page 3

Masquer les pouces Voir aussi pour S1500 DMX:

Publicité

Les langues disponibles

Les langues disponibles

After this period of time, the fog generator is cooled so much down that the thermostat switches off. Wait a
few minutes until the working temperature is reached again. It is recommended to produce smoke with small
pauses in between so that the temperature is maintained and the thermostat doesn't switch off.
Location
Select a location where it is easy to fill the tank. It is also possible to hang the unit by means of the supplied
holder and fixing screws.
Switching the unit off
Switch the unit off by unplugging it from the mains. Otherwise the 1500W heating element will draw
unnecessarily current.
Timer remote control
Connect the remote control to the connector on the back of the fogger.
After some warm-up time, the device is ready for use, the LED will light up on the remote. During use, it
may happen that the machine stops, in this case the LED will go out, indicating that the machine is warming
up. Timer function:
Press the yellow button and set the interval, duration and volume controls to the desired level.
Interval: time between the smoke moments (10-200 seconds)
Volume: amount of smoke (0-
100%) Duration: duration of the
smoking time Continuous
function:
Press the red button and set the volume to the desired level. The machine will continueously produce an
amount of smoke. It may be that the machine in between have to warm up, during this period no smoke is
produced. How many times this is done depends on the amount of smoke.
Manual Mode:
Press the green button to produce 100% smoke immediately; this button overrides all previous settings.
DMX control
Connect the device directly to a DMX controller or a DMX loop with multiple DMX effects. The machine has
a 3-pin XLR connector for DMX connection.
Address Setup:
Use the DIP switch on the rear panel to set the start address. The base/start address is defined as a first
channel, where responsive to the device. Check if no overlapping channels are used! Example addressing:
DMX address
DIP on
DIP 4
10
DIP 2
DIP 5
24
DIP 4
Value for DIP switch
8
2 (8+2 = 10)
16
8 (16+8 = 24)
Diagram

Publicité

loading

Ce manuel est également adapté pour:

160.492