Positioning And Connecting The Device; Use - MAXXMEE KLP-B025 Mode D'emploi

Mobile cooling device
POSITIONING AND
CONNECTiNG THE DEVICE
Please Note!
■
The device must have clearance of at
least 1 m above it and to all sides and
be placed on a dry, even, solid and
moisture-resistant surface.
■
Only connect the device to a plug
socket that is properly installed and
matches the technical data of the
device. The plug socket must also be
readily accessible after connection so
that the connection to the mains can
quickly be isolated.
1. Position the device at the location
you want. When you do this, push the
device carefully so that the water in
the water tank (10) does not spill out.
2. Secure the device to stop it rolling
away by moving the castor lock (8)
on the two front castors (9) to the ON
position.
3. Fully unwind the connecting cable
and connect it to an easily accessible
plug socket. You will hear a beep. All
elements on the control panel (2) will
light up and go out with the exception
of the operating lamp POWER (25).
The device is in standby mode.

USE

Please Note!
■
Do not use the device without water.
The pump could be damaged.
■
Do not move the device during
operation. Before the location of the
device is changed, switch off the de-
vice and disconnect it from the mains
power.
■
Do not operate the device unsuper-
vised so that you can intervene imme-
diately if there are any faults.
03088_Inlay_DE-EN-FR-NL_A5_V2.indb 17 03088_Inlay_DE-EN-FR-NL_A5_V2.indb 17
IMPROTANT: When you fi rst use the
device, allow it to run for a few hours in a
well-ventilated room. This will eliminate
the device's new smell and you can then
fully enjoy the cooling effect.
1. Fill the water tank (10) (see the "Filling
the Water Tank" chapter).
2. Position the device at the location you
want and connect it (see the "Posi-
tioning and Connecting the Device"
chapter).
3. Touch the POWER fi eld (25) to switch
on the device. The device starts to
operate on speed level 1. The ioni-
sation ION (18) and the cooling and
humidifying function COOL (24) are
activated.
4. Adjust the settings of the device to
suit your individual needs (see the
"Functional Overview of the Operat-
ing Elements" chapter).
 
The air fl ow can be increased
or decreased. To do this, move
one of the side levers (15) on
the ventilation grille (3) manually
up or down. This will adjust the
horizontal slats of the ventilation
grille.
5. If the device is no longer going to
be used, switch off the device via the
POWER fi eld and pull the mains plug
out of the plug socket.
EN
17
04.09.2020 14:34:27 04.09.2020 14:34:27