Filling The Water Tank; Remote Control 1 X; Inserting / Changing Batteries In The Remote Control - MAXXMEE KLP-B025 Mode D'emploi

EN
Remote Control
The buttons on the remote control
(Picture D) correspond to the functions
of the operating elements on the control
panel (2). Only the function of the COOL
button is different.
Whereas the COOL fi eld (24) on the
control panel is intended both for acti-
vating and deactivating the cooling and
humidifi cation, this function can only be
activated using the COOL button on the
remote control. To deactivate the function
and accordingly switch to pure ventilation
without cooling, the WIND button on the
remote control must be pressed.

FILLING THE WATER TANK

Please Note!
■
Only ever fi ll the water tank with
cold tap water. Do not use any other
liquids.
■
Do not overfi ll the water tank (max.
10 l)! Electrical components could be
damaged. Increased risk of an electric
shock.
1. Make sure that the device is not con-
nected to the mains power.
2. Flip open the cover (1).
3. Carefully pour cold tap water into the
water tray (17). When you do this,
make sure that the water tray does
not overfl ow.
4. Flip the cover shut.
The water runs out of the water tray into
the water tank (10) below the honeycomb
fi lters (4).
Alternative Filling
To fi ll the water tank, the device may
alternatively also be taken apart.
1. Release the two closure clasps (11) of
the water tank on the sides of the de-
vice by levering them up from below.
16
03088_Inlay_DE-EN-FR-NL_A5_V2.indb 16 03088_Inlay_DE-EN-FR-NL_A5_V2.indb 16
2. Reach into the recessed grips, lift up
the top part of the device and detach
it from the water tank. Please note!
Always place the detached part down
on a moisture-resistant surface.
3. Fill the water tank (Picture C).
4. Place the detached part of the device
on the water tank. Make sure that
the water level indicator (6) is facing
forwards.
5. Fix the water tank with the closure
clasps on the housing (13).
 
For an even better cooling result,
ice packs (not supplied with the
device) or ice cubes can option-
ally also be placed in the water
tank.
INSERTING / CHANGING
BATTERIES IN THE
REMOTE CONTROL
Before inserting the batteries, check
whether the contacts in the remote
control and on the batteries are clean,
and clean them if necessary.
1. Slide open the battery compartment
cover in the direction of the arrow and
take it off.
2. Take out used batteries if necessary
and replace them with two new bat-
teries (1.5 V; AAA). Pay attention to
the correct polarity (+ / –).
3. Place the battery compartment cover
on the battery compartment and slide
it counter to the direction of the arrow
to shut it.
Replace the batteries if the power of the
remote control starts to wane.
04.09.2020 14:34:26 04.09.2020 14:34:26