DeLonghi HVF3555TBCA Mode D'emploi page 12

Functioning and use
Make sure the appliance is off before plugging into the outlet.
1. Plug the appliance into the outlet. The light comes on.
Your appliance has a timer, see the section "Models with
24 hour timer". However, to operate the appliance with-
out programming, move all the teeth of the timer to the
outside.
2. Turn the thermostat dial to maximum.
3. Summer mode (fan only): turn the function selector
to the position.
4. Low power operation: turn the function selector to
position 1 (the fan operates at minimum).
5. Medium power operation: turn the function selector
to position 2 (the fan operates at medium).
6. High power operation: turn the function selector to
position 3 (the fan operates at maximum).
7. Switching off: turn the function selector to the "0" po-
sition.
Setting the thermostat
Position the thermostat on maximum. When the room has
reached the required temperature, turn the thermostat dial
slowly counter clockwise until you hear a click and the fan
goes off. The thermostat will then keep room temperature at
the selected level automatically.
Frost prevention mode
With the function selector in position 3 and the thermostat
dial in position , the appliance maintains room tempera-
ture at about 5°C (41°F), preventing freezing with minimal
energy consumption.
24 HOUR TIMER
After setting the thermostat and function selector to the re-
quired position, to programme heating, proceed as follows:
- turn the timer disk clockwise until the pointer on the
timer s lines up with the number corresponding to the
current time.
- set the times when you want the appliance to operate
by pushing the teeth towards the outside. Each tooth
corresponds to 30 minutes.
THE TIMER IS SET FOR THE FOLLOWING
PERIODS OF OPERATION:
FROM 11 TO 13: ON
FROM 13 TO 18: OFF
FROM 18 TO 20: ON
FROM 20 TO 11: OFF
POINTER ON
CURRENT TIME 10.00
TEETH IN THE "
ON" POSITION
The appliance will now function automatically each day at
the times set.
Please note: To use the appliance without program-
ming, push all the teeth outwards.
MOTORIZED ROTATING BASE
Some models have a motorized rotating base. To distribute
the air flow over a larger area, press the pedal. The appliance
swings from right to left. To stop the appliance in the desired
position, simply press the pedal again.
MAINTENANCE
- Always unplug from the outlet before cleaning.
- Clean the air intake and outlet grilles regularly.
- Do not use abrasive products or solvents to clean the ap-
pliance.
12
TEETH IN THE
"ON" POSITION
TEETH IN THE "OFF"
POSITION