Publicité
Les langues disponibles
Les langues disponibles
V4.0
ASSEMBLING THE SANDING BELT BOARD
The sanding belt board (Fig. 3-1) protects the
work piece during sanding.
1.
Mount the sanding belt board so that the
board touches the backside of the sanding
belt. To adjust, unscrew both screws.
2.
Adjust the board and tighten the
screws again.
IMPORTANT! For work such as polishing or
sanding bent pieces, remove the sanding belt board.
ADJUSTING THE SANDING BELT
The belt adjustment is factory set so that the
sanding belt will run centrically through
the pulleys.
1.
If the sanding belt does not run straight,
adjust the run of the sanding belt with the
adjusting knob. (Fig. 4-1)
2.
If you turn the knob clockwise, the belt
moves to the right (facing the sander). By
turning counter-clockwise the belt moves to
the left.
ADJUSTING THE SANDING TABLE
For most work, mount the sanding table at a 90° angle to the sanding belt. The
sander is equipped with a positive stop in order to enable quick positioning the
sander table to 90° angle to the sanding belt.
Adjust the stop as follows:
Visit www.princessauto.com for more information
Combination Belt and Disc Sander
8532293
Fig. 3
Fig. 4
9
Publicité
