Publicité
Les langues disponibles
Les langues disponibles
V4.0
REMOVING AND INSERTING THE SANDING BELT
Before making any adjustments or changing any accessory, turn off the tool and
unplug it from its power source.
1.
Unscrew the cover locking knob (#25) and remove the acrylic glass cover.
2.
Unscrew both hex screws that secure the sanding belt bracket cover (#27).
3.
Remove the cover. The rear drive wheel is spring supported. Press the
adjusting knob (#49) to push the wheel slightly forward in order to remove
the sanding belt out of the wheels.
4.
Insert the new sanding belt onto the wheels.
5.
Turn the belt with your hand and observe the movement. If the belt runs in
the middle of the wheels or if the belt slides sideways. Turn the adjusting
knob to adjust the position of the wheel and to correct the run of the
sanding belt.
6.
Attach the sanding belt bracket cover again and tighten the cover with the
hex screws.
7.
Place the acrylic glass cover onto the bracket cover and secure them with
the cover locking knob.
REMOVING THE SANDING DISC
The sanding disc (#67) is glued to the sanding disc plate (#70).
Before making any adjustments or changing any accessory, turn off the tool and
unplug it from its power source.
1.
To remove the sanding disc, detach the sanding disc table (#64) and the
sanding disc guard (#71).
2.
Carefully remove the used sanding disc.
3.
Remove the remaining adhesive residues.
4.
Stick a new sanding disc of the same diameter onto the disc plate.
5.
After fixing a new sanding disc, attach the sanding disc guard and the
sanding disc table onto the sander.
Visit www.princessauto.com for more information
Combination Belt and Disc Sander
8532293
13
Publicité
