Stick Mode; Stick Mode Setting; Control Mode Setting - Pro-Tronik PTR-6A Mode D'emploi

8 STICK MODE SETTING

2 CARACTERISTIQUES

8.1 CONTROL MODE SETTING

Your transmitter offers 4 different control modes named MODE 1 to MODE 4. The control mode of a transmitter sets the
distribution of the four axes of control on both sticks as follows :
Your transmitter offers an exclusive feature to change control mode without opening the transmitter to operate on the
mechanical sticks.
This device consists of a MODE slide button located on the back of the transmitter above the battery housing.
PROCEDURE
1/ Place the MODE button on the back of the transmitter to the desired position (MODE 1 for Mode 1 and Mode 3 or
Mode 2 for MODE 2 and MODE 4)
2/ hold the ENTER and EXIT keys pressed simultaneously then turn the transmitter ON
2/ Once in the MODE menu, press ENTER to enter the MODE sub-menu.
3/ Finally press UP or DOWN keys to set the control mode to the desired value. This value is displayed in the upper left of
the screen.
If the MODE button is set to MODE 1, you can choose between Mode 1 and Mode 3.
If the MODE button is set to MODE 2, you can choose between Mode 2 and Mode 4.
4/ Press the EXIT button to save your setting and return to the MODE screen menu.
5/ turn your transmitter OFF.
The transition from Mode 1 to Mode 2 or Mode 3 Mode
4 causes a reversal of Gas and Ailerons.
The transition from Mode 1 to Mode 3 leads in turn
reversing the direction and Ailerons.
Modes 1 and 3 position the stick throttle right.
Modes 2 and position the stick throttle left
UP/DOWN
UP/DOWN
37