Rx Antenna Position; Rx Wiring; Rx Power; Receiver Power Supply - Pro-Tronik PTR-6A Mode D'emploi

4 OVERALL FEATURES 2 CARACTERISTIQUES
4.3 RECEIVER ANTENNA POSTION
The sensitivity of the receiver antenna is similar to the transmitter antenna. The waves are received optimally on the
sides of the active part of the antenna (part measuring 30 mm at the end of the black extension measuring about 11 cm).
« EXTENSION » part
The active part of the antenna must be installed strictly straight and away from any electrically conductive element
(metal, carbon ...). Otherwise, the effect of "masking" occurs, greatly reducing the range.
4.4 WIRING THE RECEIVER
The receiver has 7 connectors. The connector marked
CH1 CH6
marked to
INDICATION
CH1
CH2
CH3
CH4
CH5
CH6
BAT

4.5 RECEIVER POWER SUPPLY

The installation of the receiver and servos in the model deserves your attention. These materials are nominally designed
to operate with a supply voltage between 4.8 V and 8,4 V.
The power supply must be connected to the connector marked
power connector in strict accordance with the position of the negative supply, spotted on the edge of the receiver. Any
errors or delays meaning a pin up or down can lead to immediate destruction of the receptor and / or servos connected
to it.
!
The destruction caused by the receiver or offset reverse connection is not covered by warranty.
In practice, there are two main ways to feed the reception of a model. They differ mainly by the fact that the battery
powers the reception or on the contrary by the presence of a regulator.
are intend to be connected to the servos and ESC following :
FONCTION
AILERON
PROFONDEUR
GAZ
DIRECTION
TRAIN
VOLET
ALIMENTATION
S
« ACTIVE »
Part
BAT/PPM
is intended for power supply. The 6 other connectors
The marking on the edge of the receiver shows the connector pinouts.
It is imperative to respect strictly, otherwise destruction of the
receptor and / or servos may occur.
-
Negative
+
Positive
Signal
BAT/PPM BAT/PPM
Strong.
S
S
emitted waves is
high.
Weak.
W
emitted waves is low.
S Sensitive.
Level of received
waves is high.
W
W Weak.
received waves is
low.
on the receiver. It is essential to insert the
Level of
Level of
Level of
31