Télécharger Imprimer la page

Beko SGA 8328 B Mode D'emploi page 10

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
2
Important safety and environmental instructions
• Use the appliance with a grounded
outlet.
• Do not use the appliance with an
extension cable.
• Do not pull the power cable when
unplugging the appliance.
• If the power cable is damaged, it
should be repaired or replaced
by the dealer, service center, or a
specialised and authorised service
with similar qualifications.
• Unplug the appliance before
cleaning.
• Do not wrap the cable around the
appliance.
• Do not touch the appliance or
its plug with damp or wet hands
when the appliance is plugged in.
• The soleplate of the appliance
may get too hot. Contact with hot
surfaces may cause burns.
• Never use the appliance in or
near places where combustible or
inflammable ambiance or places
are present.
• Make sure that the appliance
is cold before opening the lime
removal cover. After using the
appliance, you should wait for
about 2 hours before opening the
cover of the appliance.
10 / EN
• If you keep the packaging
materials, store them out of the
reach of children.
WARNING: Do not soak the
steam station (6) in water or other
A
liquids. Never put vinegar, descaling
agent, laundry starch, perfume or
other auxiliary products that help
ironing into the appliance.
WARNING: Do not use gasoline,
A
solvent and abrasive cleaning
agents or hard brush to clean the
appliance.
WARNING: Do not wash your
B
appliance under running water or do
not soak it in water or other liquids.
A
WARNING: Do not use abrasive
cleaning agents to clean the
soleplate (11).
C
Operation of the pump may make
some noise during the water
drawing process; this is normal.
WARNING: Never direct the
steam to people or pets.
WARNING: Do not allow the iron
A
to contact with metal parts such as
zippers and rivets. This may damage
the soleplate of the iron.
WARNING: In the automatic
shutdown mode, the product will
A
not shut down if you press the on/
off button (4) until you unplug it.
The on/off button will start to flash
in ten minutes and the product will
switch to stand-by.
Steam Generator / User Manual

Publicité

loading