Frequently Asked Questions/ Troubleshooting - VITO PRO POWER VISCME305 Mode D'emploi

FREQUENTLY ASKED QUESTIONS/ TROUBLESHOOTING

Question/problem - cause
Cause
The power tool does not switch on:
• The power cord is unplugged or there is an electrical
breakdown;
• The extension cord is too long or the wire too thin;
• The supply voltage is too low;
• Motor overheating;
Excessive vibrations:
• Loose fixing screws or parts;
• The blade is not installed correctly;
• The workpiece dimensions are larger than the appliance
cutting capacity;
The sliding miter saw is constantly burning the material:
• The blade is damaged;
• The workpiece is being pushed too fast;
Poor cutting performance:
• The saw blade is damaged or dirty;
• The saw blade is not ideal for the intended task;
• The saw blade is mounted upside down;
36
Solution
• Check the plug, socket and circuit breaker of the power
supply circuit;
• Remove or replace the extension cord.
Plug the power cord directly into the socket;
• Check that the supply voltage is adequate;
• Let the power tool cool for 2 minutes and then turn it back
on;
• Tighten the fixing screws and secure the loose parts;
• Install the blade correctly;
• Use workpieces according to the cutting capacity of the
tool;
• Replace the blade;
• Push the workpiece more slowly;
• Clean and replace the blade;
• Replace the saw blade with the correct one;
• Reinstall the saw blade correctly;