Adjusting The Bevel Angle; Using The Slide Rail; Cutting Procedure; Laser Guide - VITO PRO POWER VISCME305 Mode D'emploi

Adjusting the bevel angle

1. Loosen the bevel locking knob to tilt the cutting head to the
left according to the desired bevel angle (0°- 45°);
2. To tilt the head to the right, you need to pull out the bevel
locking tab (17);
3. The bevel angle indicator marks the selected angle on the
scale.

Using the slide rail

The slide rail (3) allows the cutting head move along the
workpieces, enabling larger cuts to be made;
To cut with the cutting head fixed in a certain position:
1. Slide the cutting head back and tighten the fixing screw on
the slide rail;
When performing a slide cut:
2. Loosen the head fixing screw and push gently cutting head
along the slide rail.

Cutting procedure

1. Lift the saw head and pull it out over the workpiece without
cutting;
2. Press the trigger switch (19);
3. Press the saw head down and push the saw through the
workpiece.
Do not pull the saw through the workpiece when the
power tool is running.

Laser guide

Use the laser guide (5) to ensure that you cut the part to the
desired size.
To switch on the laser, press the switch (21).
The laser is powered by 2 x 1.5V batteries (AAA), which
are not included.
34

Sliding miter saw transport

Always secure moving parts before transporting the appliance;
1. Ensure that the spindle is secured;
2. Ensure that the miter locking handle (12) is locked tightly;
3. Slide the cutting head back and tighten the fixing screw;
4. Push the cutting head down and press the head lock-down
pin (22);
5. Always carry the tool by the carrying handle.
The lower position of the cutting head, is for transport and
storage purposes only. Do not use the saw head in this
position to perform cutting operations.